Ask WWGOA: Turning Tool Recommendations

Ask WWGOA banner

Question:

I’m new to turning. I bought a Jet 12-20 lathe. I have one full length Easy Wood Rougher. I need to buy more turning tools. Since I’m new and want to learn to do “coves” and “beads” would you recommend continuing with the Easy Wood System or going to the standard gouges, skews etc.? Funds are limited but I will buy “one” quality tool at a time over a period of months. Also, if you recommend “standard” what do I look for in a good set of tools or brand?

Submitted by anonymous

Answer:

As you’re turning skills advance you’ll want to transition from scraping to shearing. You can have a look at this video to see what shearing beads looks like. I love the fact that the Easy Wood tools don’t require sharpening, allowing more time for turning. Check with them to see if you can get the results from their tools you’d get from shearing with “conventional” lathe chisels. If you do choose to go down the conventional road I’d stick with high speed steel lathe chisels. With the rougher in hand I’d buy a gouge next, then a skew.

George


Do you have a question for WWGOA? Ask us on Facebook or email editor@wwgoa.com. Note: questions may be edited for clarity and relevance.

Share tips, start a discussion or ask one of our experts or other students a question.

Make a comment:
500 characters remaining

3 Responses to “Ask WWGOA: Turning Tool Recommendations”

  1. william Mechura

    none

  2. Jerry Kruger

    George In turning, when you attach a face plate to a piece of wood and then glue it to a paper and then attach it to the base to be turned, what glue should you use? Is gorilla wood glue ok?

  3. christopher_dies

    Hello everyone ! Corny right...I just starting out woodworking , last time was in high school ! Anyway the problem i'm having is when i go to use the joiner on a piece of wood (side edge) the cut bows which doesnot make for a good edge.Could someone help me with this . Its a small 6" joiner sits on work bench . thank you