Oct. 13, 08 - 10:10PM
need to make outfeed table for my delta contractor saw
would like to have it long enough so I can cut plywood
my floor is not even my shop is in a barn
so someway I need to put ajustment bolt and t nut screw imto the legs would like have some ideas
Submitted: Tall Man
Jan. 04, 09 - 08:58AM
Drill holes for the T-nuts, then use adjustable feet... .
Not trying to be funny, but you seemed to have answered your own question. You can get T-nuts in standard threadings that will work with several different types of adjustable feet at just about every Home Depot and/or Lowe's. .
I would try to use a guide block or a hand drill with a leveling bubble on the butt to drill the legs; shouldn't be much of an issue as the T-nuts should only require a hole 1/2 to 3/4 inch deep.
Hope this helps...!
Submitted: Shredimaster
You must Log In to post.
